TIPPET SETTING OF HINO ENGINE
TIPPET SETTING PROCESS
To set the Volve Clerance of Hino engine, first of all we have to open all the accessories above the tippet cover, then open the tippet cover, then start the engine rotate, the top of the lower flywheel has a mark of 1/6. Have to bring the top in. As soon as the 1/6 mark comes in the top, then the engine stops rotating, after that the ranker has to check that 1/2 is free from the front or 11/12 number on the back side. It is okay if the number 1/2 ahead is free, otherwise it is okay otherwise the engine has to rotate one round and bring it to the same 1/6 mark as it gets to 1/6. From that time, start the Volve Clerance. To get a ring of 14-15 will be screwdrivers and Tippet Gajde, Adjusting at Volve Clerance INLET-0.30MM or 12 TH. and adjusting at EXJUST- 0.45MM or 18 TH. to lock type 14 to lock type. Lose it happen The will of all the then Skro will Tippet loose so will loose the Skro to adjust accordingly Tippet gauge and tight so Volve Clerance we have one cylinder.
- FAST MARK IN 1/6
To do Volve Clerance, first of all we have to rotate the engine to 1/6 mark and then we have to set the Volve Clerance number of both the number cylinder of 1 number cylinder. Volve Clerance We have to set both Intel and Exhaust wall.
- SECOND MARK 3/4
The engine has to rotate slowly and bring the 3/4 number mark to the top, then we have to set the Volve Clerance of both the rankers of the 4 number cylinders in the same way as we mentioned in the first step.
- THIRD MARK 2/5
Again we have to slowly rotate the engine directly and bring the 2/5 number mark to the top, now we have to set the Volve Clerance number of both the number 2 cylinder with the same number of Intel And Axjust wall as we Volve Clerance in the first and second step. Had set a round of engine has been completed in which we have set Volve Clerance of 1 number 4 number and 2 number cylinder.
NEPTUNE ENGINE TIPPET ADJUST
TATA 1210 ENGINE TIPPET ADJUST
KIRLOSKER ENGINE TIPPET ADJUST
- FOURTH MARK 1/6
Again we have to rotate the engine slowly and bring the 1/6 mark to the top, now we have to set both the Volve Clerance rank of the 6 number cylinder.
- FIFTH MARK 3/4
Again the engine has to be rotated slowly and the 3/4 mark is to be put in the top, after that we have to set the Volve Clerance number of both rankers of the 3 number cylinder.
- SIXTH MARK 2/5
Again we have to rotate the engine slowly and bring the mark of 2/5 to the top, then we have to set both the Volve Clerance rankers of the 5 number cylinders, then the second round has also had the Volve Clerance in which we have 6 numbers 3 numbers and 5 Number type of cylinder is set.
So friends, you can set the Volve Clerance of single-single cylinder type of Ashok Leyland 2518 Hino engine.
Friends, how did you like This information, write in the comment, if you like it, like it and share it with friends, follow us to read other similar posts, what will happen, friends, whenever I upload a post, then throw the notification Will find it